NOTES: UNLESS OTHERWISE SPECIFIED

1. ONLY CRITICAL_ AND REFERENCE DIMENSIONS ARE_ SHOWN ON THIS DRAWI NG.THE ACTUAL_ PART MUST BE EQUAL_ T0 THE_ ELECTRONIC DATA FILE OFTHE 3D MODEL. ALL UNSPECIFIED FEATURES, EDGES AND SURFACES SHALLBE_ EQUAL TO THE ELECTRONIC DATA_ FILE WITHIN TOLERANCE OF +0.10 OF THE MEASURED DISTANCE FROMTHE BASE DEFAULT COORDINATE SYSTEM.

2. SEE BOM FOR MATERIAL AND PART SPECIF ICATION

3. SURFACE FINISH: 1.8 Ra OR BETTER

4. D GATE LOCATIONS: ON SURFACE IN APPROXIMATE LOCATION SHOWN. ON BOTH SIDES OF PART

5. PARTING LINE MISMATCH: 0.1 MAX

6. FLASH: 0.1 MAX

7. GATE VESTIGE: 0.2 MAX

8. EJECTOR PINS T0 BE FLUSH T0 0.2 BELOW SURFACE

9. SYMBOL DES IGNATIONS:

    PLUS DRAFT: PRINT DIMENS 10N MEASURED AT

    SMALLEST POINT ON FEATURE DUE T0 DRAF T

    MINUS DRAFT:_ PRINT_ DIMENSION MEASURED AT

    LARGEST POINT ON FEATURE DUE T0 DRAFT

10. NO EJECTOR PINS ON INDICATED SURFACE

11. MASS: 0.22土0.05 GRAMS

    (DENSITY: 2.7 G/CM^3)

12. INDICATED SURFACES TO BE FREE OF SURFACE IMPERFECTIONS PER IS0 8785

13. CRITICAL INTERFACE GEOMETRY， REFERENCE 3D MODEL FOR GEOMETRY .

14. PLACE CAVITY 1.D. IN APPPROX IMATE LOCATION US ING

     1.0 TALL X 0.1 RAISED CHARACTERS .

15. PLACE TOOL 1.D. IN APPPROXIMATE LOCATION US ING

     1.0 TALL X 0.1 RAISED CHARACTERS

16. THIS PART MUST COMPLY WITH LIMITATIONS IN  L IST OF BANNED

     SUBSTANCES. SEE       DOCUMENT NO. 4235 006 0337

KEY CHARACTERISTIC CRITICAL TO FUNCTION (2 TOTAL )

CRITICAL T0 QUAL 1TY - SEE QAA (2 TOTAL )